Safety Data Sheet

According to GHS (Global Harmonized System) - Hazcom 2012
Date Printed (YYYY-MM-DD): 2016-05-09 

Section 1 - Product and Company Information

Product Name: Plastic Magic
Product Part Number(s): 1050-1, 1050-4
Recommended Use: A surface modifier that eliminates the paint peeling problems on automotive plastics.
Revision Date (YYYY-MM-DD):

COMPANY IDENTIFICATION:EMERGENCY TELEPHONE NUMBER
Polyvance24 Hour Emergency ContactChemtrec - 1-800-424-9300 (Outside USA 703-527-3887)
1128 Kirk Rd.Customer Information Number256-638-4103 (7AM - 4PM (CST) M-F)
Rainsville, AL 35986
Information Email: info@polyvance.com

Section 2 - Hazards Identification

Appearance:Clear liquid
Odor:Characteristic
Hazard Statement:
 WARNING! Fire or projection hazard. Flammable liquid and vapor. Pressurized container: may burst if heated. May cause an allergic skin reaction. Causes eye irritation.  

Signal Word:  

WARNING!
Signal Word Hazard:   Flammable Liquid
GHS Physical Hazard PictogramsGHS Health Hazard PictogramsGHS Environmental Hazard Pictograms

Flammable

Irritant
 
Not Applicable

GHS Hazards Statement Codes for This Product

Statement
Type
Statement
Code
Statement Text
Physical H204 Fire or projection hazard
Physical H226 Flammable liquid and vapor
Physical H229 Pressurized container: may burst if heated
Health H317 May cause an allergic skin reaction
Health H320 Causes eye irritation
Precautionary Statement:
 Keep out of reach of children. Read label before use. Keep away from heat/sparks/open flames/hot surfaces - No smoking. IF ON SKIN: Wash with soap and water. 

GHS Precautionary Statement Codes for This Product

Statement
Type
Statement
Code
Statement Text
General P102 Keep out of reach of children
General P103 Read label before use
Prevention P210 Keep away from heat/sparks/open flames/hot surfaces - No smoking
Response P302+352 IF ON SKIN: Wash with soap and water

Potential Health Effects

Eye Contact:Nasal and respiratory irritation, dizziness, headache, nausea, possible unconsciousness, and asphyxiation.
 
Skin Absorption:Moderate irritation, redness, blurred vision.
 
Inhalation:Dizziness, breathing difficulty, headaches, and loss of coordination.
 
Ingestion:Gastrointestinal irritation, vomiting, diarrhea.
 

Section 3 - Composition/Information on Ingredients

Component CAS # ENIECS REACH Reg. No. Amount
 
Chlorinated Polyolefin 24937-78-8 0 - 2%
Heptane 142-82-5 45 - 50%
Methyl Ethyl Ketone 78-93-3 1 - 2%
Resin Proprietary 0 - 2%
Toluene 108-88-3 45-50%

Section 4 - First Aid Measures

Eye Contact: Immediately flush eyes with excess water for 15 minutes, lifting lower and upper eyelids occasionally.
 
Skin Contact: Immediately flush skin with excess water for 15 minutes removing contaminated clothing.
 
Inhalation: Remove to fresh air. If not breathing, give artificial respiration.
 
Ingestion: Call Poison Control immediately. Aspiration hazard. Rinse mouth with cold water. Give victim 1-2 tbsp of activated charcoal mixed with 8 oz. of water.
 
Medical Conditions Aggravated by Exposure: Bronchitis, CNS disorders, allergies, nausea.
 

Section 5 - Firefighting Measures

Extinguishing Media: Foam, dry chemical, water fog
 
Fire Fighting Procedures: Respiratory equipment should be worn to avoid inhalation of concentrated vapors. Water should not be used except as a fog to keep nearby containers cool.
 
Unusual Fire and Explosion Hazards: Handle as a flammable liquid. Vapors form an explosive mixture in air between the lower and upper explosive limits which can be ignited by many sources such as pilot lights, open flames, electric motors and switches.
 

Section 6 - Accidental Release Measures

Steps to be Taken if Material is Released or Spilled: Remove all sources of ignition. Allow volatile portion to evaporate completely. Avoid breathing vapors and remove with inert absorbent.
 
Personal Precautions: Use personal protection recommended in Section 8. Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Remove all ignition sources and ventilate area.
 
Environmental Precautions:
 

Section 7 - Handling and Storage

General Handling: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Avoid spontaneouscombustion of contaminated rags or other ignitable material. Keep out of reach of children.
 
Other Precautions: Use with adequate ventilation and do not breathe dust or vapor. Avoid contact with skin, eyes, or clothing. Wash hands thoroughly after handling.
 
Storage: Do not store near heat, sparks or flame. Store in well ventilated area. Keep closure tight and container upright to prevent leakage. Do not puncture or incinerate. Do not spray near fire or open flames.
 

Section 8 - Precaustions to Control Exposure / Personal Protection

ComponentSourceTypeValueRemarks
Aliphatic Petroleum NaphthasOSHAPEL400 ppmSTEL
Aliphatic Petroleum NaphthasACGIHTLV300 ppmTWA
Aliphatic Petroleum NaphthasOSHAPEL300 ppmTWA
HeptaneACGIHTLV500 ppmSTEL
HeptaneACGIHTLV400 ppmTWA
HeptaneOSHAPEL500 ppmTWA
HeptaneOSHAPEL500 ppmSTEL
Isopropyl AlcoholACGIHTLV400 ppmSTEL
Isopropyl AlcoholACGIHTLV200 ppmTWA
Isopropyl AlcoholOSHAPEL400 ppmTWA
Isopropyl AlcoholOSHAPEL500 ppmSTEL
XyleneOSHAPEL150 ppmSTEL
XyleneOSHAPEL100 ppmTWA
XyleneACGIHTLV150 ppmSTEL
XyleneACGIHTLV100 ppmTWA

Personal Protective Equipment (PPE):

Eye/Face Protection: Goggles or side-shielded safety glasses.
 
Skin Protection: Neoprene or butyl rubber gloves.
 
Respiratory Protection: Use of a NIOSH approved chemical/mechanical filter, designed to remove a combination of particles and vapors.
 
Hygenic Measures: Wash hands before eating, smoking or using the washroom.
 
Other Protection Measures: To prevent repeated or prolonged skin contact, wear impervious clothing and boots. Wash contaminated clothing before reuse.
 
Engineering Controls: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV(s)
 


Section 9 - Physical and Chemical Properties

Appearance: Petroleum odor
 
Color: Clear, colorless liquid.
 
Odor: Mild odor.
 
ph: Not determined
 
Flash Point: 23°F (-5°C)
 
Upper Flammable Limit: 11.5%
 
Lower Flammable Limit: 1%
 
Autoignition Temperature: 434°F (223°C)
 
Vapor Pressure: Not available
 
Boiling Point: 180.0
 
Vapor Density: Heavier than air
 
Specific Gravity: 0.80
 
Freezing Point: Not available
 
Melting Point: Not available
 
Solubility in Water: Not Soluble
 
Evaporation Rate: 5.8 (butyl acetate = 1)
 
Partition Coefficient: Not available
 
Decomposition Temperature: Not available
 
Percent Volitiles: 97%
 
Volitile Organic Compounds (VOC): 6.32 lb/gal (757 g/l)
 
Visosity: Not available

Section 10 - Stability and Reactivity

Stability/Instability: Stable
 
Conditions To Avoid: Excessive heat, poor ventilation, open flames, sources of sparks.
 
Incompatible Materials: Alkaline materials, strong acids, and oxidizing materials.
 
Hazardous Polymerization: Will Not Occur
 
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, various hydrocarbons, oxides of nitrogen, chlorine and possibly acrolein.
 

Section 11 - Toxicological Information

Ingestion Toxicity: Not available
Skin Absorption:Not available
Inhalation
Not available
 
Sensitization
Not available
 
Acute Dose
Not available
 
Repeated Dose Toxicity
Not available
 
Chronic Toxicity and Carcinogenicity
Not available
 
Corrosivity
Not available
 
Neurological
Not available
 
Reproductive Toxicity
Not available
 
Genetic Toxicity
Not available
 
Eye Irritation
Not available
 
Skin Irritation
Not available
 
Target Organs
Not available
 

Section 12 - Ecological Information

ECOTOXICITY
Toxic to terrestrial and aquatic plants and animals. Do not release to the environment.
 

Section 13 - Disposal Considerations

Disposal Method:
Do not incinerate. Dispose of in accordance with local, state and federal regulations. Do not contaminate lakes, streams or other water supply.
 
Container Disposal: Disposal must be made according to official regulations.
 

Section 14 - Transport Information

DOT

Proper Shipping Name: Paint related material
 
Hazard Class: 3
 
ID Number: UN1263
 
Packing Group: II
 
Additional DOT Shipping Information: NMFC 149980 Sub 03 Freight Class 60
 

IMDG (Maritime transport)

IMDG Class: 3
 
UN Number: UN1263
 
Label: Flammable Liquid
 
Packaging Group: II
 
EMS Number: F-E, S-E
 
Proper Shipping Name: PAINT RELATED MATERIAL
 

IATA (Air Transport)

ICAO/IATA Class: 3
 
UN/ID Number: UN1263
 
Label: Flammable Liquid
 
Air Packaging Group: II
 
Proper Shipping Name: Paint related material
 

Section 15 - Regulatory Information

Superfund Amendments and Reathorization Act of 1986 (Emergency Planning and Community Right-to-Know Act of 1986) Sections 311 and 312

The following table list hazardous components and the regulatory lists for which they are required to be reported.

Component: Vinyl Acetate Copolymer
CAS Number: 24937-78-8
Amount:

Component: Heptane
CAS Number: 142-82-5
Amount: 45-50%

Component: Methyl Ethyl Ketone
CAS Number: 78-93-3
Amount: 1 %

Component: Chlorinated Polyolefin
CAS Number: N/A
Amount:

Component: Toluene
CAS Number: 108-88-3
Amount: 45-50%
Toluene is known to the State of California to cause cancer.

HMIS Rating (Scale 0 - 4)

HEALTH  2  Health = 2
FIRE  3  Fire = 3
PHYSICAL  1  Physical = 1
PERSONAL PROTECTION G Personal Protection = G

NFPA Ratings

 3 
2 0
Health = 2
Fire = 3
Reactivity =0

Section 16 - Other Information

Legend
CASChemical Abstract Service
CFRCode of Federal Regulations
EINECSEuropean Inventory of Existing Commercial Chemical Substances
EPAEnvironmental Protection Agency
HMISHazardous Materials Identification System
IARCInternational Agency for Research on Cancer
MSDSMaterial Safety Data Sheet
NFPANational Fire Protection Association
NIOSHNational Institute for Occupational Safety and Health
NTPNational Toxicology Program
OELOccupational Exposure Limit
OSHAOccupational Safety and Health Administration
PELPermissible Exposure Limit
REACHRegistration, Evaluation, Authorisation and Restriction of Chemicals
RELRecommended Exposure Level
STELShort Term Exposure Limit
TLVThreshold Limit Value
TWATime Weighted Average

DISCLAIMER
This Safety Data Sheet (SDS) is prepared in compliance with GHS Hazcom 2012. The information may be based in part on information provided by component suppliers and is believed to be correct as of the date hereof. However, no warranty or merchantability, fitness for any use, or any other warranty is expressed or is to be implied regarding the accuracy of of this data, the results to be obtained from the use of the material, or the hazards connected with such use. Since the information contained herein my be applied under conditions beyond our control and with which we may be unfamiliar, and since data made available subsequent to the date hereof may suggest modification of the information, we assume no responsibility for the result of its use. This information and material is furnished on the condition that the person receiving it shall make his/her own determination as the the suitability of the material for his/her particular purpose and on the condition that he/she assume the risk of his/her use thereof.