Safety Data Sheet

According to GHS (Global Harmonized System) - Hazcom 2012
Date Printed (YYYY-MM-DD): 2018-01-31 

Section 1 - Product and Company Information

Product Name: Insta-Weld Activator
Product Part Number(s): 2303-1, 2303-3, 2303-6, 2303-1F, 2303-6F
Recommended Use: Instant adhesive.
Revision Date (YYYY-MM-DD):

Polyvance24 Hour Emergency ContactChemtrec - 1-800-424-9300 (Outside USA 703-527-3887)
1128 Kirk Rd.Customer Information Number256-638-4103 (7AM - 4PM (CST) M-F)
Rainsville, AL 35986
Information Email:

Section 2 - Hazards Identification

Appearance:Clear Liquid
Hazard Statement:
  Highly flammable liquid and vapor. May be harmful if swallowed. May be harmful in contact with skin. Causes eye irritation.  
Signal Word Hazard:   Highly flammable liquid and vapor
GHS Physical Hazard PictogramsGHS Health Hazard PictogramsGHS Environmental Hazard Pictograms



Health Hazard
Not Applicable

GHS Hazards Statement Codes for This Product

Statement Text
Physical H225 Highly flammable liquid and vapor
Health H303 May be harmful if swallowed
Health H313 May be harmful in contact with skin
Health H320 Causes eye irritation
Precautionary Statement:
 Keep out of reach of children. Read label before use. Do not get in eyes, on skin, or on clothing.  

GHS Precautionary Statement Codes for This Product

Statement Text
General P102 Keep out of reach of children
General P103 Read label before use
Prevention P262 Do not get in eyes, on skin, or on clothing

Potential Health Effects

Eye Contact:Irritation on contact
Skin Contact:Prolonged exposure may cause skin irritation.
Skin Absorption:Irritation (Est. Demmal LD50 > 2000Mg./Kg)
Inhalation:May cause nausea, headache, dizziness and irritation of respiritory tract.
Ingestion:If significant quantity ingested, may dull senses (Oral LD50 > 5000)

Section 3 - Composition/Information on Ingredients

Component CAS # ENIECS REACH Reg. No. Amount
Acetone 67-64-1 <30%
Heptane 142-82-5 >69%
N,N-Dialkyltoluione 99-97-8 <1%

Section 4 - First Aid Measures

Eye Contact: Immediately flush with plenty of water for 15 minutes. Get medical attention if irritation occurs.
Skin Contact: Flush with plenty of soap and water for 15 minutes.
Inhalation: Remove to fresh air immediately.
Ingestion: Do no induce vomiting. Seek medical attention.
Medical Conditions Aggravated by Exposure: Bronchitis, CNS disorders, allergies, nausea.

Section 5 - Firefighting Measures

Extinguishing Media: CO2, Foam, Dry chemical
Fire Fighting Procedures: Firefighters should wear self contained breathing gear and protective clothing.
Unusual Fire and Explosion Hazards: Direct water jet will spread burning material. Water should not be used except as a fog to keep nearby containers cool. Combustion products are very toxic & highly irritating. Vapors form an explosive mixture in air.

Section 6 - Accidental Release Measures

Steps to be Taken if Material is Released or Spilled: Permit only properly portected workers with skin and eye protection and breathing gear. Absorb small spills with absorbant material, or let evaporate in well ventilated area. Pump large spills into salvage tanks.
Personal Precautions:
Environmental Precautions:

Section 7 - Handling and Storage

General Handling: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervouse systemdamage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmfull or fatal. Avoid spontaneous combustion of contaminated rags or other ignitable material. Keep out of reach of children.
Other Precautions:
Storage: Keep containers closed when not in use. Keep away from open flames and excessive heat.

Section 8 - Precautions to Control Exposure / Personal Protection


Personal Protective Equipment (PPE):

Eye/Face Protection: Safety glasses with eye shields.
Skin Protection: Resistant plastic or rubber.
Respiratory Protection: Above TLV. NIOSH/MESSA approved respirator.
Hygenic Measures: Wash hands before eating, smoking, or using the wash washroom.
Other Protection Measures: Protective plastic or rubber apron.
Engineering Controls: Local exhaust recommended.

Section 9 - Physical and Chemical Properties

Appearance: Water thin, very low viscosity. Sharp chemical odor
Color: Clear
ph: Not determined
Flash Point: 30F
Upper Flammable Limit: 7
Lower Flammable Limit: 1.1
Autoignition Temperature: Not available
Vapor Pressure: Not available
Boiling Point: 208
Vapor Density: Heavier than air
Specific Gravity: 0.684 @77F
Freezing Point: Not available
Melting Point: Not available
Solubility in Water: Not Soluble
Evaporation Rate: Not available
Partition Coefficient: Not available
Decomposition Temperature: Not available
Volitile Organic Compounds (VOC): 707 g/L
Visosity: Not available

Section 10 - Stability and Reactivity

Stability/Instability: Stable
Conditions To Avoid: Excessive heat, poor ventilation, open flames, sources of ignition.
Incompatible Materials: Strong oxidizers, acids & bases. May react violently with aluminum on porlonged contact.
Hazardous Polymerization: Will Not Occur
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide.

Section 11 - Toxicological Information

Ingestion Toxicity: Not determined
Skin Absorption:Not determined
Not determined
Not determined
Acute Dose
Not determined
Repeated Dose Toxicity
Not determined
Chronic Toxicity and Carcinogenicity
Not determined
Not determined
Not determined
Reproductive Toxicity
Not determined
Genetic Toxicity
Not determined
Eye Irritation
Not determined
Skin Irritation
Not determined
Target Organs
Not determined

Section 12 - Ecological Information

Movement & Partitioning
Not determined
Persistence and Degradability
Not determined
Not determined
Not determined

Section 13 - Disposal Considerations

Disposal Method:
Landfill or incinerate in accordance with EPA and local regulations.
Container Disposal: Disposal must be made according to official regulations.

Section 14 - Transport Information


Proper Shipping Name: Flammable Liquid, n.o.s. (acetone, heptane, toluid
Hazard Class: 3
ID Number: UN1993
Packing Group: II

Section 15 - Regulatory Information

Superfund Amendments and Reathorization Act of 1986 (Emergency Planning and Community Right-to-Know Act of 1986) Sections 311 and 312

The following table list hazardous components and the regulatory lists for which they are required to be reported.

Component: N,N-Dialkyltoluione
CAS Number: 99-97-8
Amount: <1%

Component: Heptane
CAS Number: 142-82-5
Amount: >69%

Component: Acetone
CAS Number: 67-64-1
Amount: <30%
Acetone is listed in SARA 313

HMIS Rating (Scale 0 - 4)

HEALTH  1  Health = 1
FIRE  3  Fire = 3
PHYSICAL  1  Physical = 1
PERSONAL PROTECTION G Personal Protection = G

NFPA Ratings

1 0
Health = 1
Fire = 3
Reactivity =0

Section 16 - Other Information


This Safety Data Sheet (SDS) is prepared in compliance with GHS Hazcom 2012. The information may be based in part on information provided by component suppliers and is believed to be correct as of the date hereof. However, no warranty or merchantability, fitness for any use, or any other warranty is expressed or is to be implied regarding the accuracy of of this data, the results to be obtained from the use of the material, or the hazards connected with such use. Since the information contained herein my be applied under conditions beyond our control and with which we may be unfamiliar, and since data made available subsequent to the date hereof may suggest modification of the information, we assume no responsibility for the result of its use. This information and material is furnished on the condition that the person receiving it shall make his/her own determination as the the suitability of the material for his/her particular purpose and on the condition that he/she assume the risk of his/her use thereof.